ATORN RVE base reference unit/height 30 mm diameter 1 60 mm/2 35 mm/M8

Application

The balancing joint units are mainly used to compensate for inaccuracies to a zero-point clamping system.
In clamping situations where the required accuracy of a part to be clamped to the zero-point system is not guaranteed,
the balancing joint units (AVE) can be mounted instead of the locating bolts from the respective manufacturer.
Along with a reference joint unit (RVE), install several balancing joint units (AVE).
By clamping the zero-point plate, the upper and lower parts of the AVE are clamped in the respective position to one another.
Usually, these are horizontally compensated, though vertical inaccuracies too can be bridged with the corresponding AVE.

Execution

• The reference unit forms the starting point and must be positioned near the workpiece zero point, if applicable.
• Made of case-hardening steel 16MnCr5.
• Tenifer QPQ-coated.

Advantage

• Components and workpieces where the required precise positioning of the zero-point pin
  is not guaranteed e.g. due to thermal deformation, inaccurate manufacture or similar,
  can be clamped without any problems using the balancing joint units.
• Due to the higher position of the workpiece, drilling through and milling of the base grip is possible in some cases.

Notes

As a rule, only one reference unit is installed.

Delivery

1x base reference unit with adapter rings; locating bolts not included